Yokogawa Integral Oxygen Analyzer ZR202 Manuel d'utilisateur télécharger pdf (Page 107)

<8. Detailed Data Setting>

8-1

IM 11M12A01-02E 8th Edition : Jan.13,2012-00

8. Detailed Data Setting

8.1 Current Output Setting

This section describes setting of the analog output range.

8.1.1 Setting Minimum Current (4 mA) and Maximum

Current (20 mA)

To set the minimum and maximum currents, proceed as follows:

(1) Select [Commissioning] in the Execution/Setup display.

(2) Select the “mA-output setup” in the Commissioning display.

(3) Select “mA-output1” in the mA-outputs display.

(4) Select “Min. oxygen conc” in the mA-output1 range display and press the [Enter] key. The

numeric-data entry display then appears. Enter the oxygen concentration for the minimum

current (4 mA); for example, enter “010” for 10 vol%O

(5) Select “Max. oxygen conc” in the mA-output1 range display and enter the oxygen

concentration for the maximum current (20 mA) in the same manner as in step 4 above.

(6) Set mA-output2 in the same way as the setting procedure for mA-output1 given above.

8.1.2 Input Ranges

The range low and high values are restricted as follows:

The range min. O

concentration value (corresponding to 4 mA output) can be set to either 0

vol%O

or in the range of 6 to 76 vol%O

The range max. O

concentration value (corresponding to 20 mA output) can be set to any value

in the range of 5 to 100 vol%O

, however the range max. setting must be at least 1.3 times the

range min. setting.

If you do not observe this restriction, the measurement will be invalid, and any previous valid

value will be used. The gray area in gure represents the valid setting range.

Setting example 1

If the range minimum (corresponding to 4 mA output) is set to 10 vol%O

then range maximum

(corresponding to 20 mA output) must be at least 13 vol%O

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 189 190

Pas de commentaire

Yokogawa Integral Oxygen Analyzer ZR202 Manuel d'utilisateur Page 107