Yokogawa Standalone MW100 Manuel d'utilisateur télécharger pdf (Page 14)

IM CA150E

When using RSLogix 500

with controllers such as the MicroLogix

series that have on board Ethernet support, the Setup Screen

looks slightly different instead of a Node Address, direct input of the MW100 IP address is allowed (no gateway or DF1 to EIP

routing is required in this case).

Write Message as conﬁ gured in a MicroLogix

or SLC 505

with EIP support

An explicit message should be triggered on/off by some sort of logic; the following image represents using the seconds bit of the

PLC’s clock to activate the message.

Time Based Message Write

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 30 31

Pas de commentaire

Yokogawa Standalone MW100 Manuel d'utilisateur Page 14