Yokogawa PC-Based MX100 Manuel d'utilisateur télécharger pdf (Page 1)

User’s

Manual

Yokogawa Electric Corporation

IM MX100-74E

6th Edition

WARNING

• Topreventelectricshockandinstrumentbreakdown,donotconnectthepower

supplytothemainmodulewhenattachingmodules.

Attachment Procedure

1. Checkthatthepowersupplyisnotconnectedtothemainmodule.

2. Aligntheconnectorontherearpanelofthemoduletotheconnectoratthedesired

positionofthebaseplateandinserttheconnector.

 Whentheconnectorsarecorrectlyconnected,theguidepinontherearpanelofthe

moduleisinsertedintotheguideholeonthebaseplate.Inaddition,themoduleis

securedtothebaseplatewiththelatchleverlockinginplaceatthebottomsectionof

thebaseplate.

3. Fastentheattachmentscrews(M3)atthetopofthemodule.

Toremovethemodule,loosentheattachmentscrew,pulldownonthelatchleveronthe

rearpanelofthemodule,andpullthemodulestraightfromthebaseplate.

Base plate connector cover

(accessory sold separately)

Input/Output module

Module attachment screw

Module connector

Screw holes

Guide holes

MX100

Main module

Base plate

Latch lever

(Pull up to remove the module

from the base plate.)

Guide pins

MW100

Main module

Screw holes

Guide holes

Module connector

Base plate

Base plate connector cover

(accessory sold separately)

Input/Output module

Module attachment screw

Base plate

Latch lever

(Pull up to remove the module

from the base plate.)

Guide pins

MX100 Main module

MW100 Main module

Can be attached by hooking the top section of the cover to the top edge of the base plate and pressing down on the lower section of the

cover

When attaching the module, be sure that the module

connector is vertical to the base plate so that the

module connector pins are not bent.

Note

• Attachthemainmoduletotheright-mostpositiononthebaseplate.

• The30-CH,MediumSpeedDCV/TC/DIInputModuletakesupthreemodulesworthof

spacewhenattachingtothebaseplate.Ifattachedincorrectly,damageormalfunctioncan

result.

• The10-CH,PulseInputModuleiscompatiblewiththeMW100.

6thEdition:September2013(YK)

AllRightsReserved,Copyright©2013YokogawaElectricCorporation

MX100/MW100

Handling of the Input/Output Modules

1 2 3 4

MX100/MW100 1
IM MX100-74E 2

Résumé du contenu

Page 1 - MX100/MW100

User’sManualYokogawa Electric CorporationIM MX100-74E6th EditionWARNING• Topreventelectricshockandinstrumentbreakdown,donotconnectthepower

Page 2 - IM MX100-74E

2IM MX100-74EAttachment Positions and Channel NumbersThefigurebelowshowshowthechannelnumbersareidentifiedonthePC.MX100012345Slot number001

Page 3

3IM MX100-74ECAUTION• Ifalargepullingforceisappliedtotheinput/outputsignalwiresconnectedtotheMX100andMW100,theterminalorsignalw

Page 4

4IM MX100-74E• Donotapplyavoltageexceedingthevalueindicatedbelowtotheinputterminalsofthe10-CH,High-SpeedDigitalInputmoduleandth