Yokogawa DAQWORX Manuel d'utilisateur télécharger pdf (Page 15)

2-6

IM WX1-06E

2.4 Starting/Stopping Data Monitoring

Before carrying out the procedure below, retrieve the channel information of the target

MX100s in advance according to the instructions given in section 2.3, “Retrieving

Information about the Target MX100s/MW100s.”

Procedure

Starting Data Monitoring

Click the Start Monitoring button or choose Start Monitoring from the Monitoring menu.

Click

Note

• If GateMX/MW is connected to the MX100, Backup mode will not be enabled when the

communication is cut while monitoring data. Even if the /DS option is enabled, the Dual

Save feature will not operate.

• If the initial communication with the target fails, retry ten seconds after the communication

failure is confirmed. Additional time is required from the start of communication until the

failure is recognized.

Displaying Run Status While Monitoring Data

Click the Run tab.

You can also choose Run from the View menu.

Click

Monitor interval specified on the MX100

The maximum and minimum channel numbers of the channel range assigned

to the same monitor interval.

The number of channels assigned to the same monitor interval

Number registered in the MX100 unit list under System.

Computer name of the PC running the

client software that is connected

(Maximum number of connections: 16)

Assigned system number

Acquisition Status

Green: Normal (running)

Red: Error (stopped, not able to connect, or there is no

corresponding channel to monitor data.)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

Yokogawa DAQWORX Manuel d'utilisateur Page 15